Related Manuals for Girard Systems 98GC782
Summary of Contents for Girard Systems 98GC782
- Page 1 12 Volts Multichannel Wall Switch RV AWNING PRODUCTS 1361 CALLE AVANZADO, SAN CLEMENTE, CA 92673 (800) 382-8442 FAX (949)276-5500 www.girardrv.com...
- Page 2 Shore Power – if connected; Generator Power – if the generator is running; Inverter Power – batteries must be charged for inverter operation. Girard Systems awnings are supplied with an electric motor appropriate to the product. P a g e o f 8...
- Page 3 These components must be electronically matched, programmed or paired before use. This is usually done at the Girard Systems factory. Should the need arise for the user to pair a device with the motor controller they must refer to the appropriate manual for the devices applicable to their particular installation.
- Page 4 98GC782 12 VOLT MULTI-CHANNEL WALL SWITCH Fig. 2 PRODUCT DESCRIPTION The 98GC2763B is a Multichannel RF transmitter, powered by 12 Volts DC designed to control up to 20 awnings. See figure 2 for description of each pad. P a g e o f 8...
- Page 5 Fig.1 Programming a 98GC782 Wall Switch to 98GC274B a. Supply power to the GC274B b. Press and hold the MIDDLE and RIGHT buttons on the GC274 (Fig 3) for about 3 seconds until the Green LED starts to flash. c. Press STOP (Fig. 1): The Green LED will stop blinking and remain illuminated.
- Page 6 Iluminated LCD. This unit is designed with an iluminated LCD, the LCD will start sleeping mode/standby after 30 seconds of inactivity, waking it up by pressing any button. Magnetic Holder.- This new G link transmitter was designed with a magnetic plate holder to keep it in place and make it more user friendly.
- Page 7 Buttons Description: IN Button retract the awning STOP Command OUT Button Extend the awning CH- Button Change channel Down CH+ Button Change channel Up LED Button Turns ON/OFF the light on the awning LOCK Button. By Pressing this button for 10 seconds, all the buttons Will be safety Locked UNLOCK Button.
- Page 8 3. Press the STOP button to set the channel. Smal letter o will appear on the display confirming that the channel has been changed. For queries or assistance with programming any of your G-Link devices please call Girard Systems TOLL FREE on 800–382–8442 between 7:30am and 3:30pm P.S.T. P a g e o f 8...
Need help?
Do you have a question about the 98GC782 and is the answer not in the manual?
Questions and answers