Subscribe to Our Youtube Channel
Related Manuals for Girard Systems 98GCK-49B
Summary of Contents for Girard Systems 98GCK-49B
- Page 1 98GCK-49(B , black , white Rocker Switch Control with Wired Motion Sensor Revision: 05242018 RV AWNING PRODUCTS 1361 CALLE AVANZADO, SAN CLEMENTE, CA 92673 (800) 382-8442 FAX (949)276-5500 www.girardrv.com P a g e 1 of 11...
- Page 2 Girard Systems awnings may be operated in light wind and rain conditions. When periods of heavy rain and or high wind are expected the awning must be closed. Never leave the awning open and unattended. Damage caused by wind and rain is not covered by warranty.
- Page 3 CONTENTS Description-Specification …………………………….………………….…………..3 Rocker Switch 98GC781(B), (W) ….………………….…………………….…………………4 98GC781(B), (W) Mounting Diagram ...…………………………………………….……………. 5 98GC781(B), (W) Button description ……………………………….……………………….….…6 Wind sensitivity Adjustment ……………………………….……………………….….…7 Wired Motion Sensor 98GC780(B), (W) ………………………………………………………….……8 98GC780(B), (W) Installation View …….……………………………………………….……9 Wiring Diagram .……………………………………………………….……10 Description The 98GCK-49 is a combination Standard Rocker Switch (98GC781” B” or “W”) and Hard Wire Motion Sensor (98GC780”...
- Page 4 98GC781(B), (W) Rocker Switch Fig. 1 P a g e 4 of 11...
- Page 5 Mounting Diagram: The required opening to install this rocker switch is 2.6-inch x 2.6-inch X 1.25-inch depth. Fig. 2 P a g e 5 of 11...
- Page 6 Buttons Description: IN Button retract the awning STOP Command OUT Button Extend the awning TURNS ON LED LIGHT TURNS OFF LED LIGHT Close the Awning and Turn OFF the LED Light P a g e 6 of 11...
- Page 7 Wind sensitivity Adjustment: This unit has 10 levels of sensitivity which can be adjusted directly on the rocker switch controller. 1. Pull off the cover from the rocker switch 98GC981(B), (W). set button 2. Press and hold the for 10 seconds until you hear a beep from the rocker switch controller, see Fig.
- Page 8 98GC780(B), (W) Wired Motion Sensor Fig. 3 This wired motion sensor communicates directly to the DC motor Controller 98GC781(B), (W) by RS485 Protocol. Attach the motion sensor to the lead rail using the mounting tab, see figure 2 above. P a g e 8 of 11...
- Page 9 Motion Sensor Installation view: Fig. 4 Fig. 5 P a g e 9 of 11...
- Page 10 Wiring Diagram: Fig. 6 P a g e 10 of 11...
- Page 11 Fig. 7 For queries or assistance with these devices please call Girard Systems TOLL FREE on 800–382–8442 between 7:30am and 3:30pm P.S.T. P a g e 11 of 11...
Need help?
Do you have a question about the 98GCK-49B and is the answer not in the manual?
Questions and answers