Subscribe to Our Youtube Channel
Related Manuals for Girard Systems 98GC230
Summary of Contents for Girard Systems 98GC230
- Page 1 DUAL CHANNEL WALL SWITCH 98GC230 INSTALLATION AND PAIRING GUIDE REV.12302015 RV AWNING PRODUCTS 1361 CALLE AVANZADO, SAN CLEMENTE, CA 92673 (800) 382-8442 FAX (949)276-5500 www.girardrv.com...
- Page 2 Shore Power – if connected; Generator Power – if the generator is running; Inverter Power – batteries must be charged for inverter operation. Girard Systems awnings are supplied with an electric motor appropriate to the product. Page 2 of 11...
-
Page 3: Table Of Contents
These components must be electronically matched or paired before use. This is usually done at the Girard Systems factory. Should the need arise for the user to pair a device with the motor controller they must refer to the appropriate manual for the devices applicable to their particular installation. -
Page 4: Product Description
PRODUCT DESCRIPTION The 98GC230 is a Dual channel RF transmitter, powered by two 3v Lithium batteries (CR2032) designed to control a single awning by means of three push buttons for each channel IN, STOP and OUT. As displayed in the picture below. -
Page 5: Installation
Screws are provided with the module for this purpose. The 98GC230 has an operating range of 100’ but should be mounted with as few obstructions as possible between itself and the Motor Controller it is paired with. -
Page 6: Gc136 Ac Motor Controller
Fig.1 Fig.2 To pair the 98GC230 Wall switch with a GC136 Motor controller follow the steps below. Note; When carrying out this part of the procedure each step must be executed within 10 seconds of the previous one or the module will revert to factory settings. -
Page 7: Gc274A / Gc274B Ac Motor Controllers
Lid Release Fig.3 To pair the 98GC230 Wall Switch with a GC274A or GC274B first remove the lid of the motor control module by pressing on the Lid release catches as shown in Fig.3 Note; When carrying out this part of the procedure each step must be executed within 10 seconds of the previous one or the module will revert to factory settings. - Page 8 98GC74 AC Motor Controller When pairing with the 98GC74 it is advised that the awning to be controlled is manually extended couple of feet to enable the programmer to see if the awning is responding in the correct direction when the buttons on the wall switch are pressed. The programming window for this module is only 6 seconds so please ensure that the programming instructions are read and understood before attempting to execute them.
-
Page 9: Gc732G Dc Motor Controller
GC732G DC Motor Controller Program Button Fig.4 To pair the 98GC230 Wall switch with a GC732G Motor controller follow the steps below. Note; When carrying out this part of the procedure each step must be executed within 10 seconds of the previous one or the module will revert to factory settings. -
Page 10: Gc1146C Dc Motor Controller
GC1146C DC Motor Controller To pair the 98GC230 Wall switch with a GC1146C Motor controller follow the steps below. • Identify the Remote handset which operates the DC Motor controller for the awning that the wall switch is to operate. This is likely to be either a 98GC1063 Single channel, or a 98GC1029 Multi channel handset. - Page 11 Ensure that the awning responds correctly to the wall switch by pressing the OUT, STOP and IN buttons alternately. For queries or assistance with programming any of your G-Link devices please call Girard Systems TOLL FREE on 800–382–8442 between 7:30am and 3:30pm P.S.T. Page 11 of 11...
Need help?
Do you have a question about the 98GC230 and is the answer not in the manual?
Questions and answers