Subscribe to Our Youtube Channel
Related Manuals for Girard Systems 98GCK-49B
Summary of Contents for Girard Systems 98GCK-49B
- Page 1 98GCK-49(B , black , white Switch Control with Wired Motion Sensor Revision: 02202019JM RV AWNING PRODUCTS 1361 CALLE AVANZADO, SAN CLEMENTE, CA 92673 (800) 382-8442 FAX (949)276-5500 www.girardrv.com P a g e 1 of 11...
- Page 2 Girard Systems awnings may be operated in light wind and rain conditions. When periods of heavy rain and or high wind are expected the awning must be closed. Never leave the awning open and unattended. Damage caused by wind and rain is not covered by warranty.
- Page 3 CONTENTS Description-Specification …………………………….………………….…………..3 Wall Switch 98GC781(B), (W) ….………………….…………………….…………………4 98GC781(B), (W) Mounting Diagram ...…………………………………………….……………. 5 98GC781(B), (W) Button description ……………………………….……………………….….…6 Wind sensitivity Adjustment ……………………………….……………………….….…7 Wired Motion Sensor 98GC780(B), (W) ………………………………………………………….……8 98GC780(B), (W) Installation View ..…….……………………………………………….……9 Wiring Diagram .……………………………………………………….……10 Description The 98GCK-49 is a combination Standard Wall Switch (98GC781” B” or “W”) and Hard Wire Motion Sensor (98GC780”...
- Page 4 98GC781(B), (W) Wall Switch Fig. 1 P a g e 4 of 11...
- Page 5 Mounting Diagram: The required opening to install this wall switch is 2.6-inch x 2.6-inch X 1.25-inch depth. Fig. 2 P a g e 5 of 11...
- Page 6 Buttons Description: IN Button retract the awning STOP Command OUT Button Extend the awning TURNS ON LED LIGHT TURNS OFF LED LIGHT Close the Awning and Turn OFF the LED Light P a g e 6 of 11...
- Page 7 Wind sensitivity Adjustment: This unit has a factory preset wind sensitivity setting. If assistance is needed please contact Girard technical support department at 1-800-382-8442 7:30 AM - 3:30 PM PST Monday - Friday. Reverse Motor Direction: 1. The direction of the motor can be reversed without the need of changing the wiring by pressing the IN and OUT buttons of the wall switch simultaneously for at least 6 seconds until hear a beep.
- Page 8 98GC780(B), (W) Wired Motion Sensor Fig. 3 This wired motion sensor communicates directly to the DC motor Controller 98GC781(B), (W) by RS485 Protocol. Attach the motion sensor to the lead rail using the mounting tab, see figure 3 above. P a g e 8 of 11...
- Page 9 Motion Sensor Installation view: Fig. 4 Fig. 5 P a g e 9 of 11...
- Page 10 Wiring Diagram: Fig. 6 P a g e 10 of 11...
- Page 11 Fig. 7 For inquiries or assistance with these devices please call Girard Systems TOLL FREE on 800–382–8442 between 7:30am and 3:30pm P.S.T. P a g e 11 of 11...
Need help?
Do you have a question about the 98GCK-49B and is the answer not in the manual?
Questions and answers