Table of Contents
Advertisement
3. Connect with load；
4. Set parameter of list/delayer mode；
Please refer to section Parameter Setting of List Mode and Parameter setting of Delayer Mode.
5. Enable timing/delayer output；
In timing/delayer interface, rotate rotary knob
function. Symbol
6. Disable timing/delayer output；
In timing/delayer interface, rotate rotary knob
Symbol
turn to
Another shorcut to disable output function, push
Parameter Setting of List Mode
Menu introduction of list mode
Cycle index： It divide into maximum inf and 1-999. A cycle period is start form setup origin point to end point. Push rotary
knob
to adjusting parameters.
Count: It can set "001" - "048", which is excute group from origin point to end point. Push rotary knob
point. Notice: each voltage, current and time is a point.
Origin point: It can adjust "000" - " 047" , which is start from origin point to run. ("origin point" value + "count" value ≤
048)
Mode: It divide into three mode stop, run and pasue, it can not be set；
Pause presents power supply is not output at the current；
Run presents power supply is operating；
Pause presents power supply is paused；
Notice：In pause and run mode, interface can not be adjust; pause only shown when indicator
shown on
interface.
This curve figure can direct present the setting parameter of list mode.
to
turn to
and status bar will also change to "stop" to "run";
to and push
and status bar will also change to "run" to "stop";
Interface of List Mode
The Curve Figure of Count Parameter
UDP6720 Series Digital Control Power Supply User's Manual
and push
to enable timing/delayer output
to disable timing/delayer output function.
key to turn off timing/delayer function in any interface.
19
to adjusting
is off and only
Advertisement
Table of Contents
