Table of Contents
Advertisement
UDP6720 Series Digital Control Power Supply User's Manual
Memory Group Voltage/Current Setup
Set the specific output voltage/current point and select memory key M1~M3, push it to save the current setting.
When user need to call the stored output voltage/current, enter the setup interface to select the specific memory group
and then push memory key M1~M3 to call the specific stored output voltage/current.
When user call the stored output voltage/current, the corresponding memory key will indicate green light.
Output Mode Setup
1) Push
to enter setup interface;
or
2) Push
to select the output status bar;
3) Rotate
to select Out State;
4) Output status symbol will shown on the top screen when output is finished;
5) Push
to exit the setup page.
Notice: When output function is operating, power supply should remain enable status. That is,
should keep
operating status when turn off the power supply.
14
Advertisement
Table of Contents
