Advertisement
35. Remove the expander riser card from the base metal chassis by using a T10 bit to remove the six screws
(circled red) from the expander riser card. Repeat this step for all the remaining expander riser cards and
remove all the PCBAs from the chassis.
36. Use a Phillips #1 bit to remove the SAS expander guide from the chassis.
37. Remove the side handles by using a Phillips #2 bit to remove the screws marked below. Repeat on both
sides.
MF877-00
Template Revision C, 30-July-2018
Copyright 2018 Hewlett Packard Enterprise Development LP
HPE instructions for this template are available at
MF877-01
Page 35
Advertisement
