Dishwasher Installation
STEP 16: CONNECT POWER SUPPLY
If a power cord with plug is already installed,
proceed to Step 17.
WARNING
If house wiring is not 2-wire with a ground
wire, a ground must be provided by the
installer.
When house wiring is aluminum, be sure to
use U.L. listed anti-oxidant compound and
aluminum-to-copper connectors.
Si el cableado de la casa no es de 2 cables
ADVERTENCIA
con un cable de conexión a tierra, el
#282 French
instalador debe suministrar una conexión
a tierra. Cuando el cableado de la casa es en
aluminio, cerciórese de usar un compuesto
an
ti-oxidante aprobado por U.L.
yun compuesto de aluminio a cobre.
• Secure house wiring to the back of the junction
box bracket with a strain relief.
• Locate the three dishwasher wires, (white, black
and green) with stripped ends. Insert dishwasher
wires through the small hole in the junction box
bracket. Use UL listed wire nuts of appropriate size
to connect incoming ground to green, white to
white and black to black.
Note: Check that harness leads are
threaded through small hole in bracket
White
Ground
Junction
Box Bracket
06F-1847E
Figure Z
Black
STEP 17: iNSTALL juNCTiON BOx COVER
If junction box cover is already installed, skip to
Step 18.
In this step you will need the junction box cover and
the #10 hex head screw from the screw kit set aside
in Step 1.
• Install the junction box cover using the #10 hex
head screw. Check to be sure that wires are not
pinched under the cover.
STEP 18: PRE-TEST CHECK LIST
Verify that power is turned off at the source.
■
Open the dishwasher door and remove all foam
■
and cardboard packaging.
Read the Owner's Manual to familiarize yourself
■
with the operation of the dishwasher.
Check to be sure that the wiring is secure
■
under the dishwasher, and not pinched or in
contact with door springs or other dishwasher
components.
Check that the door spring does not contact the
■
water line, fill hose, or adjacent cabinets. See
Steps 13 and 14
Pull lower rack about halfway out. Check to be
■
sure it does not roll back into dishwasher or
further out. If it does, re-level the dishwasher.
See Step 12
Check to be sure control panel does not touch
■
adjacent cabinets. If it does, reposition the
dishwasher. See Step 13
Turn on the hot water faucet at the sink to verify
■
that the water temperature is at least 120°F
and not more than 150°F. Adjust water heater
if necessary.
Add two quarts of water to the bottom of the
■
dishwasher to lubricate the pump seal.
Turn on water supply.
■
Check for water leaks. Tighten connections if
■
necessary. See Step 14
Remove the protective film if present from the
■
control panel, access panel and door panel.
13