GE GSM2260VSS Installation Instructions Manual page 3

Installation Preparation–Enclosure
PREPARE DISHWASHER ENCLOSURE AND
SINK LOCATION
• Water line to sink faucet and drain from sink can
be run through Area "A."
• Hot water line to dishwasher is installed in Area "B."
• Garbage disposer, water lines to faucet, waste
trap, air gap and water shut-off valve are installed
in a 12" wide cabinet, Area "C".
Countertop: 1-1/2" Min. Thick
10-1/4"
Max.
Area "A"
Front View
6" Max.
Area "B"
24"
PREPARE CABINET CUTOUT FOR SINK:
WARNING
To reduce the risk of shock, fire, or injury to
persons, the installer must ensure that the
923-38C
dishwasher is completely enclosed at the
time of installation.
Para reducir el riesgo de choque, incendio
ADVERTENCIA
o lesión a personas, el instalador se
debe cerciorar de que la lavadora esté
completamente cerrada en el momento
#282 French
de la instalación.
Sink
Installation
Cutout
8" X 20"
Adjacent Cabinet
24"
Rear Cutout
min
Cabinet Side
Adjacent to D/W
24" min
Figure B
7-1/2"
Area "C"
Toekick
Area
12"
Min.
Floor
5"
5"
12-1/2"
3-1/4"
12"
• Sink opening for garbage disposer must be
dimensioned as shown (7-1/2") in Area "C." This will
provide clearance for disposer and plumbing in
Area "C" when using either single or double bowl
sink. Refer to Figure A below and Figure F1 on
page 6.
11" Min.
3/4" Min.
Drain
1-1/4"
Min. I.R.
34-1/4"
1-1/2"
+ _
1/4"
Close Elbow
Figure A
• The cabinet opening must have a minimum width
and depth of 24" and height of 34-1/4" ± 1/4".
679DiaA
• This dishwasher fits under a special sink with a
depth of 6" or less in a 1-1/2" countertop.
• The dishwasher must be fully enclosed on the top,
sides and back.
• The dishwasher must not support any part of the
enclosure.
20-1/2" Max.
Sink Bowl
Tub
Front
Flange
Dishwasher
Gap
24" Min.
Cabinet
Note: A gap between the dishwasher tub front flange and
the front of the base cabinet may result due to either
the cabinet being less than 24" deep or the sink bowl
679DiaK
not being installed to specifications.
If the gap is more than 3/4", the sink bowl must be
relocated to meet specified dimensions.
Wall
20-1/2" Max.
Sink Bowl
1" Max. To
Sink Flange
6" Max.
10-1/4" MAX.
PLUMBING
A
DEPTH
11-3/4" Max.
Plumbing
Dishwasher
Side View
4"
B
Max.
24" Min.
Cabinet
Wall
3