Charcoal Filters; Hood Lights; Stainless Steel Surfaces - GE JV666HSS Owner's Manual & Installation Instructions

Care and cleaning of the vent hood.
The charcoal filters are clipped inside
of each reusable metal grease filter.

Charcoal Filters

(on some models)
The charcoal filters
cannot be cleaned.
They must be replaced.
For 30 " hood models, order
Kit no. WB02X11000.
For 36 " hood models, order
Kit no. WB02X11001.
These kits can be ordered
from your GE supplier.
Painted Surfaces
(on some models)
To clean the hood surface, use a hot,
damp cloth with a mild detergent
suitable for painted surfaces. Use a
clean, hot, damp cloth to remove soap.
Dry with a dry, clean cloth.

Stainless Steel Surfaces

Do not use a steel wool pad; it will
scratch the surface.
To clean the stainless steel surface,
use warm sudsy water or a stainless steel
cleaner or polish. Always wipe the
surface in the direction of the grain.
Follow the cleaner instructions for
cleaning the stainless steel surface.

Hood Lights

This hood requires two bulbs (not
included), maximum 50 watts.
Purchase and install PAR20, 50 W
Maximum halogen bulbs.
When replacing a bulb, let it cool first.
Make sure that power to the light has
been turned off. Never allow a hot bulb
to come into contact with water.
WARNING:
To reduce the risk of
electric shock, do not connect electrical power
to the hood without both bulbs in place.
NOTE: Charcoal filters are not
included with the hood. They
must be ordered from your
GE supplier.
If the model is not vented
to the outside, the air will
be recirculated through
disposable charcoal filters
that help remove smoke
and odors.
Do not use steel-wool pads or other
abrasive cleaners. They will scratch
the surface. Wipe with a clean, hot,
damp cloth after using cleansers.
(on some models)
To inquire about purchasing stainless
steel appliance cleaner or polish, or to
find the location of a dealer nearest
you, please call our toll-free number:
National Parts Center
800.626.2002
ge.com
To change the light bulbs:
Grasp the bulb on the edges and
unscrew it.
Replace with the same size bulb.
CAUTION:
I
Do not touch the hood light bulbs when they
are on. They may be hot enough to cause
injury.
I
The light bulbs operate at extremely high
temperatures. If they shatter, the hot glass
could cause personal injury.
ge.com
The charcoal filters should
be replaced when they
are noticeably dirty or
discolored (usually after
6–12 months, depending
on hood usage).
NOTE: DO NOT rinse, or put
charcoal filters in an automatic
dishwasher.
5