GE PV976NSS Owner's Manual & Installation Instructions page 11

TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Pencil and tape measure
Spirit level
Phillips screwdriver
Electric drill with 3/16" bits,
#2 Phillips and flat head
Step ladder
UL listed wire nuts
Aluminized Strain relief for
Duct tape junction box
120V 60Hz. 15 or 20 Amp,
2-wire with ground, properly
grounded branch circuit
Installation Preparation
Safety glasses
Hammer
Flashlight
Metal snips
Pliers
Wire cutter/stripper
Saber saw or Key Hole saw
8" round metal
duct, length to
suit installation
REMOVE THE PACKAGING
CAUTION:
against sharp edges.
• Remove the duct covers.
• Remove the hardware bag, literature package
and other boxed parts.
• Remove and properly discard the protective
plastic wrapping and other packaging materials.
• Remove packing foam from behind the blower.
11
Wear gloves to protect