Change Settings - Philips Screeneo U4 User Manual

Unpair a Bluetooth device
This will remove the Bluetooth device from the
projector's memory. You'll need to pair and
connect this device to use it again.
To unpair a Bluetooth device, press and hold
either of the buttons on the projector for 5
seconds while the device is connected. The
projector will announce "Disconnected" and
reenter pairing mode after the unpairing.
Pair more Bluetooth playback devices
To pair the projector with more Bluetooth
playback devices, disconnect the currently
connected Bluetooth playback device and
repeat steps 1-3 at the start of this section.
Note: The projector can be paired with multiple
Bluetooth playback devices, but can only
output audio from one paired device at a time.
15

8 Change settings

1 Press on the remote control to access
the projector's settings menu.
2 Use the navigation buttons and the OK
button to select a menu item.
3 Press / or / to select a value for the
menu item.
4 Press the OK button to make the change.
Note: For some menu items such as Digital
Zoom, the change takes effect once you
select a different value.
5 Press one or more times to exit the
projector's settings menu.
General settings
You can view and change the following general
settings.
• Input Source: Select the projector's input
source.
• Auto: Automatically switch to the
correct input source. This is the default
value.
• HDMI 1: Select this when your device
is connected to the projector's HDMI 1
port.
• HDMI 2: Select this when your device
is connected to the projector's HDMI 2
(ARC) port.
• Brightness Mode: Set the brightness mode
to Presentation, Normal or Night Mode. Tip:
You can more quickly change the brightness
mode by pressing
control.
on the remote
Philips · Screeneo U4