In the the heating mode, two running period scan be set
Press
nad hold for 2s to enter into the timer setting interface..
Running period 1. The symbol ON 1 on the right side of the interface and the timenparameter flash at this time.
Press
agin and the hour parameter flashes. Set the time according to the 2.6 and conforim. Then OFF 1
and the time parameter flash. Set the time following the previous steps.
Running period 2:After Running Period 1 is set, the controller will enter into the Running period 2 setting
interface. Set the start – up and shut – down time in the same way as Running period 1.
Press
to canacel any modifications during the setting.
Press
and hold for 2s twice to set the OFF 1 time directly or press
running.
Press
cancel nthe setting when the hour parameter is flashing.
14
when the unit is already