Changing The Anchor - MTI FREEDOM CORE II Product Manual

CHANGING THE ANCHOR

1
Insert IntelliKey into Power Screamer port until LED
turns green.
3
Unplug the power supply from the Power/Screamer
Anchor and remove the Power/Screamer Sensor cable
(if needed).
5
Remove excess VHB by rolling it off the surface.
www.mobiletechinc.com | T:800.426.6844
-CONTROLLED DOCUMENT-
FREEDOM CORE II™ POWER/SCREAMER SENSOR
063-00229 A-0 Status: Approved
2
Remove the three screws in the top of the Power/
Screamer Anchor using the Double-Sided System Tool.
4
Hold the Adhesive Pad Removal Tool with both hands
and using a sawing motion, pull one side of the tool,
then the other back and forth until the VHB is released
from the Power/Screamer Anchor.
6
Clean the Power/Screamer Anchor with an alcohol swab
and let air dry or wipe dry with a clean cloth. Replace
VHB with extra pads provided.
MTI P/N 063-00229 rev A ©2018 MTI All Rights Reserved
ECO-106737
8