Merchandising - MTI FREEDOM CORE II Product Manual

MERCHANDISING

1
Clean the demo device with an alcohol swab and let
air dry or wipe dry with a clean cloth. Peel the red film
from the VHB adhesive on the Sensor. If not using
GeniusCables, skip to step 6.
3
Insert the desired GeniusCable into the Sensor port.
The Sensor must be detached from device before
GeniusCable can be installed. GeniusCable is locked
into the Sensor after re-installation.
B.
5
Connect GeniusCable to device.
www.mobiletechinc.com | T:800.426.6844
-CONTROLLED DOCUMENT-
A.
063-00229 A-0
FREEDOM CORE II™ POWER/SCREAMER SENSOR
2
Using the Double-Sided System Tool, turn clockwise
and then twist to remove the Sensor from the base
plate.
Double Sided
System Tool
4
Using the pin on the Sensor for alignment, twist the
Sensor onto base plate until it snaps and locks into
place.
6
Use the individual power supply and plug it into the
nearest outlet.
The socket-outlet shall be installed near the
equipment and shall be easily accessible.
MTI P/N 063-00229 rev A ©2018 MTI All Rights Reserved
Status: Approved
Use the pin for
alignment.
ECO-106737
4