Using Transfer Tape - MTI FREEDOM CORE II Product Manual

IF USING TRANSFER TAPE
Peel the red film from the VHB adhesive on the Sensor.
1
3
Peel the film from the Adhesive Transfer Tape.
www.mobiletechinc.com | T:800.426.6844
-CONTROLLED DOCUMENT-
FREEDOM CORE II™ POWER/SCREAMER SENSOR
063-00229 A-0 Status: Approved
Place the Adhesive Transfer Tape on the Power
2
Screamer Sensor, lining up the center hole on the
Adhesive Transfer Tape with the plunger on the sensor.
4
Place on the desired device.
MTI P/N 063-00229 rev A ©2018 MTI All Rights Reserved
ECO-106737
5