Danfoss VLT DriveMotor FCP 106 Installation Manual page 8

VLT® DriveMotor FCP 106
Installation Guide
The type code is used in the fuse table. Write down the type code (T/C) and serial number (S/N) for future reference.
VLT
R Drive Motor
1
www.danfoss.com
11
T/C: FCP106P4K0T4C66H1FSXXAXX
10
P/N: 134G2844 S/N: 010400G253
9
4.0kW(400V) / 5.0HP(460V)
8
IN: 3x380-480V 50/60Hz , 8.3/6.8A
7
OUT: 3x0-Vin 0-400Hz , 9.0/8.2A
o o
Enclosure: IP66 , Tamb. 40 C / 104 F
Illustration 1: Example of the Type Code on the Nameplate
1 Type code
2 Certifications
3 Protection rating
4 Bar code for manufacturer use
5 Certifications
6 Serial number
1.8 Further Items Required
• 1 adapter plate
• 1 gasket, used between motor adapter plate and drive
• 1 motor connector
• 4 screws for fastening drive to adapter plate
• 4 screws for fastening motor adapter plate to motor
• Crimp terminals
- AMP standard power timer contacts female
- 3 pieces for motor terminals U, V, and W
- 2 pieces for thermistor (optional)
- 1 piece for grounding terminal
• 2 guiding pins (optional)
1.9 EMC-compliant Installation
For more information, refer to the operating guide.
• Use shielded cables for motor and control wiring.
• Connect the shield to the enclosures at both ends. If the shield connection points have a voltage potential difference, connect a
low impedance equalizing wire parallel to the shielded cable. Otherwise, break the shield connection on 1 end to prevent
ground current loops.
• Avoid installation with twisted shield ends (pigtails), since this type of installation ruins the shield effect at high frequencies. Use
the cable clamps provided instead.
• Ensure the same potential between drive and ground potential of the PLC.
• Use star washers and galvanically conductive installation plates.
8 | Danfoss A/S © 2022.09
N O T I C E
2 3
Enclosure rating: See manual
E134261 Ind. Contr. Eq.
MADE IN
DENMARK
* 1 3 1 U 3 9 3 0 0 1 0 1 0 2 G 2 9 0 *
6 5 4
7 Enclosure type and IP protection rating, maximum
ambient temperature without derating
8 Output voltage, frequency, and current (at low/high
voltages)
9 Input voltage, frequency, and current (at low/high
voltages)
10 Power rating
11 Code number
AN40855215838601-000101 / 130R1249
Instructions