Table of Contents
Advertisement
Steps
After performing the steps in the pre-requisites, you are left with the palm-rest and keyboard assembly.
Installing the palm-rest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the
installation procedure.
Steps
Place the palm-rest and keyboard assembly on a flat and clean surface.
Next steps
1. Install the
system
board.
2. Install the
M.2 2230 solid-state drive
3. Install the
power button with fingerprint
4. Install the
IO
board.
5. Install the
display
assembly.
6. Install the touchpad.
7. Install the
coin-cell
battery.
8. Install the speakers.
9. Install the
right
fan.
10. Install the
left
fan.
11. Install the
wireless
card.
12. Install the battery.
13. Install the
base
cover.
14. Follow the procedure in
or
M.2 2280 solid-state
reader.
After working inside your
drive, as applicable.
computer.
Removing and installing components
55
Advertisement
Table of Contents
