Table of Contents
Advertisement
9. Remove the
memory
module.
10. Remove the speakers.
11. Remove the
power adapter
12. Remove the
system
board.
NOTE:
The system board can be removed as an assembly with the fan and heat-sink assembly, ethernet and audio
board, and USB board attached.
13. Remove the
keyboard-controller
14. Remove the
power-button
About this task
After performing the steps in the pre-requisites, we are left with the palm-rest and keyboard assembly.
NOTE:
When replacing the palm-rest and keyboard assembly, the solid-state drive screw mount must be removed from the
existing palm-rest and keyboard assembly and transferred to the replacement palm-rest and keyboard assembly.
Figure 1. Location of solid-state drive holder
Installing the palm-rest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
Place the palm-rest and keyboard assembly on a flat surface.
NOTE:
When replacing the palm-rest and keyboard assembly, the solid-state drive screw mount must be transferred from
the old palm-rest and keyboard assembly to the replacement palm-rest and keyboard assembly.
port.
board, if applicable.
assembly.
Removing and installing Field Replaceable Units (FRUs)
85
Advertisement
Table of Contents
