Interface Operation - UP3D F20 User Manual

3.1.4 Interface operation

1) Sintering control button: when the hearth is not raised to the
proper position or there is a faulty pop-up, the button cannot
be activated for sintering; Otherwise, when click the sintering
control button, the triangle on it will turn into
two vertical lines and the sintering will start; then click it again,
the two vertical lines will
turn into triangle, and the sintering will be stopped.
2) Fault display box: Click on the fault display box, and a fault
code table will pop up. When the fault code pops up during the
use of the F20 sintering furnace, fault cause can be found out
from this fault code table, and the fault can be solved according
to the corresponding solution.
click click
again
09