Related Manuals for UP3D F20
Summary of Contents for UP3D F20
- Page 1 Smart Sintering Furnace www.up3ds.com User manual info@up3d.cn +86-755-26983202...
-
Page 2: Table Of Contents
CONTENTS Introduction 1.1 Description 1.2 Operation Precautions Product Description 2.1 Components 2.2 Hazardous Areas Operation and Configuration 3.1 Operating Instructions 3.2 Configuration Instructions Installation and Use 4.1 Unpacking 4.2 Assembly Electrical parameters... -
Page 3: Description
/Basic Information If you lose the manual, you can contact technical support of UP3D Tech for an additional copy. 1.1 Description Dear customers: Thank you very much for purchasing F20 smart sintering furnace /Product Description from UP3D TECH, which is suitable for sintering and crystallization of zirconia resto- rations. -
Page 4: Operation And Configuration
Hearth lift pause button: When the hearth rises or falls, 3.1.2 Control Panel click this button, and the hearth will stop rising or falling. The F20 furnace is equipped with a large colorful touch screen, all operations can be Electrical parameter display box: real-time display of voltage, Voltage Electricity current and power during sintering. - Page 5 Click on the fault display box, and a fault code table will pop up. When the fault code pops up during the use of the F20 sintering furnace, fault cause can be found out from this fault code table, and the fault can be solved according to the corresponding solution.
- Page 6 On the password input interface, click the Enter password box, and the numeric After re-entering the same new password, click OK to complete the password change. keyboard box will pop up. Note that you must remember the 6-digit new password after change. If you forget it, Put in factory password 66666 in keyboard, click OK to enter the password setting you can only restore it and reset it, which will cause the loss of the customized sinter- interface;...
- Page 7 Click the specific program or the serial number on display box to enter the program Click the Enter password box, and the numeric keyboard box will pop up. parameter interface. Put in the correct 6-digit password, if incorrect, a reminder box will pop up at the Click the program confirmation box, it means that the program is selected, and it will bottom of the password box.
- Page 8 If the 6-digit password is correct, you can enter the program parameter interface The white boxes in the parameter setting areas of heating, temperature, and temp. where parameters can be edited. preservation in the program parameter interface represent different definitions, and the range of parameter values that can be input is also different.
-
Page 9: Configuration Instructions
2. Basic factory configuration of sintering curve: (for reference only) Program code Description 3.2 Configuration Instructions UPCERA ST single crown 1. Function configuration of F20 smart sintering furnace: UPCERA ST short bridge Sintering 20 programs can be freely set by the user Easy to search program... -
Page 10: Installation And Use
Note: It is recommended to keep the package for future transportation. Rated power: 2000W 4.2 Assembly Net weight: 64kg Step 1: Place the main body of the F20 sintering furnace on the workbench surface Gross weight: 78KG specified in 1.2 Operation Precautions.