Table of Contents
Advertisement
2.2 Hazardous areas
The hazardous area of the F20 sintering furnace is shown in the table
below:
Dangerous area
Sides of furnace
Lifting areas
Furnace internal parts
03
Operation and configuration
3.1.1 Operating Instructions
06
Hazard type
Burn hazard
Crush hazard
Electric shock hazard
Power Switch, switch to I to turn on the
machine and start using.
Switch to O to turn off the machine and
stop using.
Power port, connect the configured
power cord to this port (the machine
power
Power cable is a specific power cable,
and there is a risk of wire burning if
other power cables are used)
Place the sintering tray, put the
restorations in the tray filled with
zirconium beads,
and cover the tray cover in sequence
(the tray can be stacked up to
three layers, and a maximum of 40
single crowns can be placed on each
layer)
Advertisement
Table of Contents
