Power Door Locks - If Equipped; Power Side Steps - If Equipped; Keyless Enter 'N Go™ - Passive Entry; (If Equipped) - Dodge RAM 2500 2022 Owner's Manual

Table of Contents

Advertisement

30
GETTING TO KNOW YOUR VEHICLE
P
D
L
— I
OWER
OOR
OCKS
F
The power door lock switches are located on each
front door panel. Push the switch to lock or unlock
the doors.
Power Door Lock Switches
The driver's door will unlock automatically if the
keys are found inside the vehicle when the door
lock button on the front door panel is used to lock
the door. This will occur for two attempts. Upon the
third attempt, the doors will lock even if the key is
inside.
NOTE:
If the key fob is located next to a mobile phone,
laptop, or other electronic device, the wireless
signal may get blocked, and the driver's door may
not unlock automatically.
E
If the door lock switch is pushed while the ignition
QUIPPED
is in the ACC or ON/RUN position and the driver's
door is open, the doors will not lock.
If a rear door is locked, it cannot be opened from
inside the vehicle without first unlocking the door.
The door may be unlocked manually by raising the
lock knob.
P
S
OWER
IDE
The Power Side Steps will extend a step for easier
entry and exit of the vehicle.
When configured for "Auto" mode, the Power Side
Steps will deploy when any of the doors are
opened, or when the deploy setting is activated
through the touchscreen. When configured for
"Store" mode, the steps will not deploy unless the
setting is selected manually through the Controls
menu within the touchscreen.
If the vehicle speed exceeds 5 mph (8 km/h), or if
the retract setting is selected within Uconnect
Settings Ú page 247, the steps will retract.
S
— I
E
TEPS
F
QUIPPED
K
E
'
G
™ — P
EYLESS
NTER
N
O
E
(I
E
)
NTRY
F
QUIPPED
The Passive Entry system is an enhancement to
the vehicle's key fob and a feature of Keyless
Enter 'n Go™. This feature allows you to lock and
unlock the vehicle's door(s) without having to push
the key fob lock or unlock buttons.
NOTE:
Passive Entry may be programmed on or off
within Uconnect Settings Ú page 247.
The key fob may not be detected by the vehicle
Passive Entry system if it is located next to a
mobile phone, laptop, or other electronic device;
these devices may block the key fob's wireless
signal and prevent the Passive Entry system
from locking/unlocking the vehicle.
Passive Entry unlock initiates illuminated
approach (low beams, license plate lamp, posi-
tion lamps) for whichever time duration is set
between 0, 30, 60 or 90 seconds. Passive Entry
unlock also initiates two flashes of the turn
signal lamps.
ASSIVE

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ram 3500 2022

Table of Contents