Toshiba RAV-HM401CTP Series Service Manual page 79

<RBC-AMTU3∗ ∗ ∗ ∗ ∗ >
1
Push the + +
least 4 seconds.
The unit No. displayed first is the address of the header indoor unit in group
control.
Then the fan and louver of the selected indoor unit move.
2
UNIT LOUVER
Each time the
one of the indoor unit Nos. under group control is displayed in
turn. Then the fan and louver of the selected indoor unit move.
3
Use the button to select the CODE No. (DN code) of the
TEMP.
desired function.
4
Use the button to select the desired SET DATA
associated with the selected function.
5
Push the button. (The display changes from flashing to
steady.)
• To change the selected indoor unit, go back to step
• To change the selected function, go back to step
6
When the button is pushed, the system returns to normal
off state.
NOTE :
For details on how to operate other remote controllers, refer to the remote controller manual.
buttons simultaneously and hold for at
button (left side of the button) is pressed,
3
.
2
.
- 79 -
10
CODE No.
SET DATA 00 01 SETTING TEST
UNIT No.
1-1
R.C. No.
TEMP . ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
FILTER
TEST SET CL SWING/FIX UNIT LOUVER
RESET
5 4
3
1 2
6