Toshiba RAV-HM401CTP Series Service Manual page 78

9-1-4. Function Selection Setup
<Procedure> Perform setting while the air conditioner stops.
<RBC-ASCU1∗ ∗ ∗ ∗ ∗ >
1
Push and hold menu button and [
• After a while, the display flashes as shown in the figure. "ALL" is displayed as indoor unit numbers during
initial communication immediately after the power has been turned on.
2
Each time [ ] [
change cyclically. Select the indoor unit to change settings for.
• The fan of the selected indoor unit runs . The indoor unit can be confirmed for which to change settings.
3
Push OFF timer button to confirm the selected indoor unit.
4
Push the menu button to make Code No. [
[ ] setting button.
5
Push the menu button to make Set data [
[ ] [ ] setting button.
6
Push OFF timer button to complete the set up.
• To change other settings of the selected indoor unit, repeat from Procedure
7
When all the settings have been completed, push ON/OFF button to finish the settings.
(Return to the normal mode)
" " flashes and then the display content disappears and the air conditioner enters the normal stop
SETTING
mode. (The remote controller is unavailable while "
• To change settings of another indoor unit, repeat from Procedure
3,6
4,5 1
] setting button simultaneously for 10 seconds or more.
Indoor unit No.
] setting button is pushed, indoor unit numbers in the group control
Set data
∗∗∗∗ ∗∗∗∗
∗∗∗∗ ∗∗∗∗ ∗∗∗∗
- 78 -
2,4,5
7
Code No.
∗∗ ∗∗ ∗∗ ∗∗ ∗∗
] flash. Change Code No. [
] flash. Change Set data [
" is flashing.)
SETTING
1
.
∗∗ ∗∗ ∗∗ ∗∗ ∗∗
] with [
∗∗∗∗ ∗∗∗∗
∗∗∗∗ ∗∗∗∗ ∗∗∗∗
] with
4
.
]