Titan TTI884COM Manual page 31

TTI884COM
After use
1. Switch the product off, wait for complete stop, remove the battery pack and
lit it cool down.
2. Check, clean and store the product as described below.
The golden rules for care
WARNING! Always switch the product off, remove the battery pack and
let the product cool down before performing inspection, maintenance
and cleaning work!
Only perform care and maintenance work according to these instructions!
1. Keep the product clean. Remove debris from it after each use and before
storage.
2. Regular and proper cleaning will help ensure safe use and prolong the life of
the product.
3. Inspect the product before each use for worn and damaged parts. Do not
WARNING! Only perform repairs and maintenance work according to
specialist!
General Cleaning
1. Clean the product with a dry cloth. Use a brush for areas that are hard to
reach.
2. In particular clean the air vents (5) after every use with a cloth and brush.
3. Remove stubborn dust with high pressure air (max. 3 bar).
4. Check for worn or damaged parts. Replace worn parts as necessary or
contact an authorised service centre for repair before using the product again.
NOTE:
the drill chuck by hand until the gears engage.
MNL_18V 2X 2AH Li-ION BRUSHED COMBI DRILL_V2_211220.indd 31
Product functions / Care and maintenance
EN EN
31
12/20/21 11:39 AM