Table of Contents
Advertisement
Before you start
EN
Setup
NOTE: Use a suitable bit holder to access areas that are hard to reach.
Insert the bit holder into the socket in the same way as the driver bits,
then insert a driver bit into the bit holder.
Removing / Replacing
1. Turn the chuck sleeve (2) anticlockwise until the chuck jaws (1) are opened
wide enough to remove the bit.
2. Remove the bit and insert a new one as described above if desired.
Battery pack
Attach / Release
1. Lock the on/off switch (7) to avoid accidental starting by moving the forward
/ reverse rotation control (6) into the centre position (see below section
"Product functions – Forward / reverse rotation control").
2. Align the battery pack (10) with the sliding slots of the battery docking port
(10a) and slide the battery pack in to attach it. Ensure it clicks in place
(Fig. 4).
3. Press the release button (12) and slide the battery pack (10) from the battery
docking port (12) (Fig. 5).
22
MNL_18V 2X 2AH Li-ION BRUSHED COMBI DRILL_V2_211220.indd 22
10a
10
Fig. 4
12
Fig. 5
TTI884COM
10
12/20/21 11:39 AM
Advertisement
Table of Contents
