Long Term Storage - Intex Krystal Clear Saltwater System CS7110 Instruction Manual

(189PO) MODEL CS7111 SALTWATER SYSTEM & FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 07/31/2012
Page 22
English
The Copper Ion Test Strips can be used to test the copper ion concentration in the water.
Directions and Use
1. Dip the entire strip into the water for 3 seconds, then remove it
2. Hold the strip level for 15 seconds. Do not shake excess water from the strip.
3. Now compare the copper ion strip pad to the color chart on the packaging label.
The 3‐Way Test Strips can test the "Free Chlorine", "pH", and "Total Alkalinity"levels at the same time. It is recommend that you test
the water chemistry daily, and maintain the chlorine concentration at 1.0 ‐ 3.0 ppm. This level may be lowered to 0.6‐3.0 ppm once
the copper concentration has reached 0.2‐0.3 ppm.
Directions and Use
1. Dip the entire strip into the water and remove immediately.
2. Hold the strip level for 15 seconds. Do not shake excess water from the strip.
3. Now compare the strip pad to the color chart on the packaging label. If necessary, adjust the chemical level in the pool water. It is
very important, to use the proper technique when testing the water's chemical level. Read and follow the written strip instructions
carefully.
1. Disconnect the power cord from the electrical outlet.
2. After the pool is completely empty, disconnect the Saltwater System from the hoses by reversing the installation instructions.
3. Air‐dry the unit before you store it. This might be a good time to visually inspect and clean the electrolytic cell.
4. Store the unit and accessories in a dry place. The temperature should be controlled, between 32 degrees Fahrenheit (0 degrees
Celsius) and 97 degrees Fahrenheit (36 degrees Celsius).
5. The original package can be used for storage.
MAINTENANCE (continued)
INTEX COPPER ION TEST STRIPS (PACKED WITH THE PRODUCT)
®
INTEX
3‐WAY TEST STRIPS (PACKED WITH THE PRODUCT)
®
LONG TERM STORAGE