Bosch Universal Rake 900 Original Instructions Manual page 15

Do not touch the tines before the
u
machine is disconnected from the
supply and the tines have come to a
complete stop.
Keep supply cables and extension
u
cables away from the tines. The
tines can cause damage to the cables
and lead to contact with live parts.
Beware electric shock hazard when
inspecting for potential contact
between water and electricity.
Remove the plug from the socket:
– Whenever you leave the machine.
– Before clearing a blockage.
– Before checking, cleaning or work-
ing on the machine.
– After striking a foreign object. In-
spect the machine for damage and
change the blade as necessary.
– If the machine starts to vibrate ab-
normally (check immediately).
Connecting to the mains
The voltage of the power source
u
must correspond with the data on
the type plate of the product.
Only use this product when connec-
u
ted into a socket which is protected
by a circuit-breaker that would be ac-
tuated by a 30 mA residual current.
Only use or replace power supply
u
cables for this unit which correspond
to the types indicated by the manu-
facturer. See the operating instruc-
tions for the order no. and types.
Never touch the mains plug with wet
u
hands.
Bosch Power Tools
Do not run over, crush or pull the
u
power supply cord or extension
cord, otherwise it may be damaged.
Protect the cable from heat, oil and
sharp edges.
The extension lead must have a cross
u
section in accordance with the oper-
ating instructions and be protected
against splashed water. The connec-
tion must not be in water.
Always wear gardening gloves
u
when handling or working near the
sharp blade/tines.
Electrical Safety
Warning! Switch the
product off and pull the
mains plug before any main-
tenance or cleaning. The same ap-
plies when the mains cable is dam-
aged, cut or entangled.
The blade/tines continues to ro-
u
tate for a few seconds after the
machine is switched off.
Caution do not touch the rotating
u
blade/tines.
Your product is double insulated for
safety and requires no earth connec-
tion. The operating voltage is 230 V
AC, 50 Hz (for non-EU countries
220 V, 240 V as applicable). Contact
your Bosch Service Centre for details.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service
Centre.
For electrical safety use a Residual
u
Current Device (RCD) with a tripping
English | 15
F 016 L94 116 | (17.02.2021)