Options; Installing Safety Lights; Using Safety Helmet; Using The Alignment Gauge - Invacare Top End Eliminator User Manual

12 Options

12.1 Installing Safety Lights

WARNING!
– Operation of the racing chair is subject to all
traffic rules and regulations (this may include
the use of a safety lights and reflectors for
dusk/night riding).
Batteries
1. Remove the lens cover.
2. Insert the AAA batteries with correct polarity (+ or -).
3. Reinstall lens cover.
Mounting the Safety Light
1. Remove the set screw from the clamp on the safety
light.
2. Install the safety light.
a. Rear safety light: Pull the back cushion off of the
back frame. Position the clamp onto the rear seat
post. Install the set screw into the clamp and tighten
securely.
b. Front safety light: Position the clamp onto the side
frame. Install the set screw into the clamp and
tighten securely.
Operating the Safety Light
1. Press button to turn safety light on/off.
2. Remove lens cover and slide switch back and forth for
pulse or constant mode.
60001470-A

12.2 Using Safety Helmet

1. Secure helmet using the chin strap.
2. Ensure proper fit.

12.3 Using the Alignment Gauge

1. Inflate the tires to recommended tire pressures (listed
on the sidewall of the tire).
2. Place the racing chair and alignment gauge A on a
flat surface.
3. Position the alignment gauge A near the rear of the
rear tires B.
4. Loosen the alignment screw on each side.
5. Position the alignment gauge A between the rear of
the rear tires B.
6. Adjust the alignment inserts so the alignment gauge A
fits snugly between the rear of the rear tires B.
7. Tighten the alignment screws to secure the alignment
bar position.
Helmet
Fig. 12-1
Options
51