Regulatory Information - iRobot RVB-Y2 Safety Information Manual

Regulatory Information

FCC Supplier's Declaration of Conformity
iRobot Corporation
Contains FCC ID: UFEAXE-Y1 and contains IC: 6652A-AXEY1
EN
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device contains a licence-exempt transmitter/receiver that
complies with Innovation, Science and Economic Development (ISED)
Canada's licence-exempt RSS(s). Operation is subject to the following
two conditions: 1) This device may not cause interference, and 2) this
device must accept any interference, including interference that may
cause undesired operation of the device.
• Changes or modifications not expressly approved by iRobot
Corporation could void the user's authority to operate the equipment.
• This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference to radio communication will not occur
in a particular installation. If this equipment does cause harmful in-
terference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
©2021 iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730 USA. All rights reserved. iRobot, Roomba, iAdapt and Virtual Wall are registered trademarks of iRobot
Corporation. Home Base and Dirt Detect are trademarks of iRobot Corporation. Wi-Fi and the Wi-Fi logo are registered trademarks of Wi-Fi Alliance.
Roomba Model: RVB-Y2
• Under Industry Canada regulations, this radio transmitter may only
• FCC Radiation Exposure Statement: This product complies with
• ISED Radiation Exposure Statement: This product complies with the
https://global.irobot.com
For battery recycling go to call2recycle.org;
or call 1-800-822-8837
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
operate using an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than the necessary for
successful communication.
FCC §2.1091(b) for mobile device RF exposure limits, set forth for an
uncontrolled environment and is safe for the intended operation
as described in this manual. Per FCC requirements, maintain a
distance of more than 8 inches (20cm) between any person and the
host device (Roomba robot).
Canadian Standard RSS-102 for portable RF exposure limits, set
forth for an uncontrolled environment and is safe for the intended
operation as described in this manual. Per ISED requirements,
maintain a distance of more than 8 inches (20 cm) between any
person and the robot.