Ioperation; Starting; Loading Dishes On Racks - Electrolux EL1 Series User Manual

Drain / self-cleaning cycle
This button starts a drain/self-cleaning cycle. When the cycle is
selected, the button indicator is lit up.
Wash cycle 1
This button starts Wash cycle 1. When the cycle is selected,
the button indicator is lit up. This cycle is recommended for
washing not very dirty dishes.
Wash cycle 2
This button starts Wash cycle 2. When the cycle is selected,
the button indicator is lit up. This cycle is recommended for
washing normally dirty dishes.
Wash cycle 3
This button starts Wash cycle 3. When the cycle is selected,
the button indicator is lit up. This cycle is recommended for
washing very dirty dishes.
I OPERATION
I.1

Starting

NOTE!
Carry out a couple of cycles without dishes to flush
out any industrial grease which has remained in
the tank and piping.
• Open the water supply tap.
• Switch on at the mains.
• Open the door and check that all the components are in
their correct position.
• Close the door and press On/Off button.
• The indicator light of On/Off button comes on, indicating that
the dishwasher is powered and that water is being
introduced and heated. The word "FILL" is shown on the
display during the entire filling and heating stage:
NOTE!
For atmospheric versions only: this dishwasher
does the first tank filling through several consec-
utive hot rinse cycles, while the display shows the
message "FILL" (flowing). This system let save up
to 30% of time than traditional models.
Active/Wash Safe Control indicator
In the Active/Wash Safe Control
models a special device checks
the temperature of the rinse phase.
The
SYSTEM [GRS] is an automatic
rinse
system.
The GUARANTEED RINSE SYSTEM is active:
• during the wash cycle and the indicator light is OFF;
• during the rinse cycle and the indicator light comes on and is
GREEN;
• at the end of the rinse cycle. The indicator light is GREEN if
the rinse temperature and time have been carried out as per
the programme, otherwise the indicator light is RED;
• upon opening the door, the indicator light GOES OUT.
NOTE!
If the indicator light is RED, for example should the
boiler waiting time be disabled, wait for a couple of
minutes and then repeat the wash cycle.
• If the door is opened during this stage the message
"CLOSE" will appear on the display:
• The filling and heating stage has finished when the display
shows the tank temperature:
• To display the boiler temperature during heating of the tank,
open the door and press the Wash cycle 1 button.
IMPORTANT
For Thermal Label compliant models the display
shows 75℃.
I.2

Loading dishes on racks

The appliance is suitable for washing dishes, glasses, cups,
cutlery, containers and receptacles in plastic and/or steel used
for preparing, cooking and serving; as well as a wide variety of
ceramic and/or metal cooking utensils. However it is advisable
not to wash decorated dishes or place silverware in contact
with other metals.
GUARANTEED RINSE
time/temperature control
15