Table of Contents
Advertisement
Model 6517B Electrometer User's Manual
Unpacking and inspection for damage
The 6517B was carefully inspected electrically and mechanically before shipment.
There may be a protective film over the display lens, which can be removed.
Before removing the 6517B from the antistatic bag, observe the following handling precautions:
•
Always grasp the 6517B by the cover.
•
After removing the 6517B from its antistatic bag, inspect it for any obvious signs of physical
damage. Report any damage to the shipping agent immediately.
•
When the 6517B is not installed and connected, keep the instrument in its antistatic bag and store
it in the original packing carton.
Save the original packing carton for future shipment.
Returning instrument for service
If you need to return the 6517B for repair or calibration, call 1-800-408-8165 or complete the form at
https://www.tek.com/en/services/repair/rma-request.
When you request service, you need the serial number and firmware or software version of
the instrument.
Shipment contents
The following items are included with every 6517B order:
•
Model 6517B Electrometer with line cord
•
237-ALG-2 Low Noise Triaxial Cable, 3-slot triaxial to alligator clips, 2 m (6.6 ft)
•
8607 Safety High Voltage Test Leads
•
6517-TP Thermocouple Bead Probe
•
CS-1305 Interlock Connector
•
Accessories as ordered
•
Certificate of calibration
Options and accessories
Check
tek.com/keithley
6517B-900-01 Rev. B August 2022
for options and accessories that are available for use with the 6517B.
Section 1: Introduction
1-3
Advertisement
Table of Contents
