Jobsite IR-CB2 Datasheet page 2

Two zone ir connecting blocks, for routing infrared commands from two ir receivers to five sources

Hide thumbs Also See for IR-CB2:

IR-CB2

TWO ZONE IR CONNECTING BLOCK

FEATURES

• Provides two IR receiver inputs to accommodate receivers with

Zone 2 capabilities

• Selectable high/low emitter outputs for use with IR-E1HO high output emitter

or single and dual emitters

• 12V DC status input jack and LED indicator

INSTALLATION FRIENDLY DESIGN:

• Snap and lock connector secures wire in place without the use of a

screwdriver

• Wings allow for either vertical of horizontal mounting

• 3.5mm emitter output jacks

• Includes in-line UL listed regulated power supply

SPECIFICATIONS

• IR system: Works with practically all brands of IR remote controls

• Connections: 2 receiver inputs, 5 emitter outputs

• Home runs required from each IR receiver

WIRING REQUIREMENTS:

• Category 5 or better

MOUNTING:

• Wall or flat surface: use drywall screws

DIMENSIONS:

• 5-11/16" wide x 1-1/4" high x 2" deep

POWER REQUIREMENTS:

• 110V to 12V DC power supply (included)

WARRANTY:

• 2 year limited

TWO ZONE IR CONNECTING BLOCK

JOBSITE SYSTEMS

12331 SW 130 STREET

MIAMI, FL 33186

P 866.4JB.SITE (866.452.7483)

F 305.238.0185

WWW.JOBSITESYSTEMS.COM

IR-CB2