ActionTec ScreenBeam Pro SBWD100B User Manual page 28

I encounter connection failure with the Receiver and my device
can't connect to it any more.
Reboot the Receiver and try connection again. Or, reboot your device
•
(laptop/Ultrabook/tablet/smartphone) and try connection again.
Reboot both the Receiver and your device and try connection again.
•
If you are using a Windows 8.1 operating system, go to Change PC
•
settings > PC and Devices > Devices > Projectors, remove the profile
of ScreenBeam Pro from your device (PC/laptop/Ultrabook), and try
connection again.
If you are using an Android operating system, go to WLAN > WiFi
•
Direct > Remembered Groups, remove the profile of ScreenBeam Pro
from your device, and try connection again.
I can't connect to the Receiver with ScreenBeam Configuration
Utility on my device. The Utility can't find the Receiver.
In Windows 8.1, you must connect your device to the Receiver at least
one time. In doing so, the profile of the Receiver is saved to your device.
Then the Utility on your device can connect to the Receiver.
In Windows 7/8, you must connect your device to the Receiver with Intel
WiDi first, and then the Utility on your device can connect to the
Receiver.
In Windows 8.1, I can't adjust the screen size with the ScreenBeam
Configuration Utility. I can't find the screen size adjustment
option.
The screen size adjustment option is not available if your device doesn't
connect to the receiver. You must connect your device to the Receiver
first, and then launch the Utility and configure the receiver.
!
ScreenBeam Pro Receiver
28