Unsatisfactory Results; General Problems Or Technical Faults - Miele KM 7200 FR Operating And Installation Instructions

Problem solving guide

Unsatisfactory results

Issue
The food in the pan
does not heat up when
the Auto heat-up
function is switched on.

General problems or technical faults

Issue
The hob or cooking
zones will not switch
on.
A smell and vapours are
given off when the new
appliance is being used.
An operating noise can
be heard after the
appliance has been
switched off.
54
Cause and remedy
A large amount of food is being heated up.
 Start cooking at the highest power level and then
turn down to a lower one manually later on.
The pan is not conducting heat properly.
 Use a different pot or pan which conducts heat
properly.
Cause and remedy
There is no power to the hob.
 Check if the mains fuse has tripped. Contact a
qualified electrician or your Miele dealer (for the
minimum fuse rating, see data plate).
There may be a technical fault.
 Disconnect the appliance from the electricity
supply for approx. 1 minute by
– tripping the relevant mains fuse or screwing the
fuse out completely, or
– switching off at the residual current device.
 If, after resetting the trip switch in the mains fuse
box or the residual current device, the appliance
will still not turn on, contact your Miele dealer.
The metal components have a protective coating.
When the appliance is used for the first time, this
causes a smell and possibly also vapour. The
material from which the induction coils are made also
gives off a smell in the first few hours of operation.
With each subsequent use, the odour is reduced until
it disappears completely. The smell and any vapours
given off do not indicate a faulty connection or
appliance and they are not hazardous to health.
The cooling fan runs until the hob has cooled down
and then switches off automatically.