Unsatisfactory Results; General Problems Or Technical Faults - Miele SmartLine CS 7612 Operating And Installation Instructions

Problem solving guide

Unsatisfactory results

Problem
The food in the pan
does not heat up when
the Auto heat-up func-
tion is switched on.

General problems or technical faults

Problem
The SmartLine element
cannot be switched on.
A smell and vapours are
given off when the new
appliance is being used.
50
Cause and remedy
A large amount of food is being heated up.
 Start cooking at the highest power level and then
turn down to a lower one manually later on.
The pan is not conducting heat properly.
 Use a different pot or pan which conducts heat
properly.
Cause and remedy
There is no power to the SmartLine element.
 Check whether the mains fuse has tripped. Con-
tact an electrician or Miele Service (for the min-
imum fuse rating, see data plate).
There may be a technical fault.
 Disconnect the SmartLine element from the mains
electricity supply for approx. 1 minute by
– tripping the relevant mains fuse or screwing the
fuse out completely, or
– switching off the residual current protection
device.
 If, after resetting the trip switch in the mains fuse
box or the residual current protection device, the
SmartLine element will still not switch on, contact
a qualified electrician or Miele Service.
The metal components have a protective coating.
When the appliance is used for the first time, this
causes a smell and possibly also vapour. The mater-
ial from which the induction coils are made also gives
off a smell in the first few hours of operation. With
each subsequent use, the odour is reduced until it
disappears completely. The smell and any vapours
given off do not indicate a faulty connection or appli-
ance and they are not hazardous to health.