Before removing the touchpad, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
Remove the touchpad:
1.
Remove the four Phillips M2.0.× 3.0 screws (1) that secure the touchpad bracket to the computer.
2.
Remove the bracket from the computer (2).
3.
Remove the Mylar and disconnect the cable from the ZIF connector on the touchpad module (1).
4.
Remove the three Phillips M2.0 × 2.0 screws (2) that secure the touchpad to the computer.
46
Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page
35).
34).
34).