WARNING
Read and understand the entire contents of
this manual before attempting assembly or
operation!
Failure to comply may cause serious injury!
Contents of the Shipping Container
1. Saw
1. Motor Cover
2. Extension Wings
Accessory Package:
1. Blade Guard Assembly
1. Hand Wheel / Handle Assembly
1. Lock Knob
1. Arbor Wrench
1. Miter Gauge Assembly
1. Blade Guard Wrench w/ Cable
1. Switch Brace
1. 8mm Hex Wrench
1. Blade Guard Mounting Bracket Assembly
Note: The blade guard wrench attached to the
blade guard shaft with a cable is included for
your convenience. Install the blade guard shaft
assembly as shipped and the wrench will always
be immediately available to adjust, install, or
remove the blade guard assembly. Always use
the blade guard whenever possible.
making cuts that require the removal of the
blade guard, use extreme caution. Replace
the blade guard immediately after finishing
those cuts that require it's removal.
Tools Required for Assembly
Metric Wrench Set or 6"-8" Adjustable Wrench
Metric Hex Wrench Set
Straight Edge
Unpacking and Clean-Up
•
Tool: 12mm Wrench
1. Remove all contents from the shipping
container.
Do not discard any shipping
material until the saw is set up and running
satisfactorily.
2. Inspect contents for shipping damage.
Report damage, if any, to your local
distributor.
3. Remove two hex cap bolts from skid
bottom.
4. Carefully move saw to its final location.
If
6