Warnings - Jet JTAS-10XL Operating Instructions And Parts Manual

WARNING
Wear eye protection.
Use the saw blade guard and spreader for every operation for which it can be used, including all
through sawing.
Keep hands out of line with the saw blade.
Use a push stick when required.
Pay particular attention to instructions on reducing the risk of kickback.
Do not perform any operation freehand.
Never reach around or over the saw blade.
1. Read and understand the entire instruction manual before attempting assembly or operation.
2. This table saw is designed and intended for use by properly trained and experienced
personnel only. If you are not familiar with the proper and safe operation of a table saw, do
not use until proper training and knowledge have been obtained.
3. Always wear approved safety glasses/face shields while using this machine.
4. Make certain the machine is properly grounded.
5. Before operating the machine, remove tie, rings, watches, other jewelry, and roll up sleeves above
the elbows. Remove all loose clothing and confine long hair. Do not wear gloves.
6. Keep the floor around the machine clean and free of scrap material, oil and grease.
7. Keep machine guards in place at all times when the machine is in use. If removed for maintenance
purposes, use extreme caution and replace the guards immediately.
8. Do not over reach. Maintain a balanced stance at all times so that you do not fall or lean against
blades or other moving parts.
9. Make all machine adjustments or maintenance with the machine unplugged from the power source.
10. Use the right tool. Don't force a tool or attachment to do a job that it was not designed for.
11. Replace warning labels if they become obscured or removed.
12. Make certain the switch is in the OFF position before connecting the machine to the power supply.
13. Give your work undivided attention. Looking around, carrying on a conversation, and "horse-play"
are careless acts that can result in serious injury.
14. Keep visitors a safe distance from the work area.
15. Use recommended accessories; improper accessories may be hazardous.
16. Never place hands directly in line with the saw blade.
17. Always use push sticks when cutting small material.
18. Raise or lower the blade only when the machine has been turned off and the blade has come to a
complete stop.
19. Read and understand warnings posted on the machine.
20. Use blade guard for every applicable operation including all through cuts. If guard is removed for
special non-through cuts such as dado and rabbet cuts, replace before further use of the saw.
21. Failure to comply with all of these warnings may cause serious injury.
22. Some dust created by power sanding, sawing, grinding, drilling and other construction activities
contains chemicals known to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
•
Lead from lead based paint
•
crystalline silica from bricks and cement and other masonry products, and
•
arsenic and chromium from chemically-treated lumber.
Your risk from those exposures varies, depending on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specifically designed to filter out microscopic particles.
23. Do not operate tool while under the influence of drugs, alcohol or any medication.
3