Unpacking; Contents Of Shipping Container; Setup - Jet JWBS-20 Operating Instructions And Parts Manual

Unpacking

Open shipping container and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the Bandsaw
is assembled and running properly.

Contents of Shipping Container

1 Bandsaw
1 Table
1 Fence and Rail Assembly
1 Resaw Guide and Knob
1 Miter Gauge
1 Owner's Manual
1 Warranty Card
1 Hardware Package, includes:
2 Knobs
1 Hex Wrench
1 Handle
1 Wrench, 10/12mm
1 Fence Hardware Bag, includes:
4 Hex Cap Screws
4 Flat Washers
4 Lock Washers
1 Rail Hardware Bag, includes:
9 Hex Cap Screws
9 Flat Washers
9 Lock Washers

Setup

1. Remove the crate and packing material from
the saw except for the transport skid on the
bottom.
2. Move the saw to its permanent working
location. The site should be dry, well lit, and
have enough room to handle long stock and
the service or adjustment of the machine
from any side.
3. Move the bandsaw off the skid.
4. Clean all rust protected surfaces with a mild
solvent or diesel fuel and a soft cloth. Do not
use lacquer thinner, paint thinner, or
gasoline. These
surfaces.
will damage painted
Tools Included for Assembly
1 10/12mm Open End Wrench
1 Hex Wrench
Tools Required
Adjustments
2 14mm Open End Wrenches
1 Cross Point Screwdriver
1 Combination Square
7
for Assembly and