Blade Raising And Tilting Mechanism; Electrical Connections - Jet JTAS-10XL Operating Instructions And Parts Manual

Blade Raising and Tilting Mechanism

1. To raise or lower the saw blade, loosen the
lock knob (A, Fig. 12) in the middle of the
handwheel and turn the handwheel (B, Fig.
12) on the saw front until desired height is
reached. Tighten lock knob. The blade
should be adjusted 1/8" to 1/4" above the
top surface of the material being cut.
2. To tilt the saw blade, loosen lock knob (C,
Fig. 12), turn handwheel on the right of the
saw cabinet (D, Fig. 12) until desired angle
is obtained, then tighten lock knob.

Electrical Connections

WARNING!

A qualified electrician must complete all
electrical connections!
Failure to comply may result in serious
injury!
The JTAS-10XL-1, JTAS-10XL-5/1 and JTAS-
12XL-5/1 table saws are rated at 230V only.
The JTAS-10XL-3 and JTAS-12XL-3 are rated
at 230/460V, and come from the factory
prewired 230V.
To switch the JTAS-10XL-3 and JTAS-12XL-3
from 230V to 460V:
1. Disconnect the machine from the power
source, (unplug).
2. Open the saw cabinet door.
3. Remove the cover from the motor junction
box.
4. Change wires following the diagram on the
inside of the cover.
5. Replace the cover and close the cabinet
door.
6. Replace the magnetic on-off switch with part
#JTAS10-23B (available
authorized JET distributor or by calling
WMH Tool Group at 1-800-274-6848).
Confirm power at the site is the same as the
saw before making any electrical connections.
Review the electrical schematics on page 32-33.
through your
11
The on and off switch is thermally protected.
If the saw motor is overloaded, or a momentary
interruption of electrical current is sensed, the
saw will shut off. Allow a few minutes for the
saw to cool down and reset by pushing the off
button.
Using extension cords can cause a loss in power
to your machine. It is best if the saw is plugged
directly into an outlet on a dedicated circuit.