Microwave Cooking; Light Control; Vent Fan Control - Danby DOM014401G1 Owner's Manual

OPERATING INSTRUCTIONS

MICROWAVE COOKING

1. Press TIME COOK.
2. Use the number pad to set the desired cooking
time. The longest time that can be set is 99
minutes and 59 seconds.
3. Press POWER LEVEL. The default power level
is 100%. Use the number pad to set a different
power level if desired as per the below chart.
4. Press START/+30SEC to begin.
Number Pad Cooking Power
1,0
9
8
7
6
5
4
3
2
1
0
TWO STAGE COOKING
Some recipes require different stages of cooking
at different temperatures. To set a two stage cook
program:
1. Enter the fi rst cooking program but do not press
the START/+30SEC button.
2. Enter the second cooking program.
3. Press START/+30SEC button to begin.
Note that defrost, sensor or soften/melt menus
cannot be set during a multi-stage cooking
program.
100% (PL10)
90% (PL-9)
80% (PL-8)
70% (PL-7)
60% (PL-6)
50% (PL-5)
40% (PL-4)
30% (PL-3)
20% (PL-2)
10% (PL-1)
0% (PL-0)

LIGHT CONTROL

The light on the bottom of the microwave can be
used to illuminate the stove top. Press the LIGHT
ON/OFF button once to turn on the light. Press this
button again to turn the light off.

VENT FAN CONTROL

The vent fan in the microwave can be used as a
range hood. This will remove smoke and odors
generated while cooking.
Press VENT once to turn on the fan using low speed.
The display will show "Vent .L".
Press VENT twice to turn on the fan using high
speed. The display will show "Vent .H".
Press this button a third time to turn the fan off.
When the microwave is in use, the fan will operate
on low speed and will stop when the program ends.
If the fan has been manually set to high speed, it
will run on high for 18 minutes and then continue
on low speed until the cooking program is done.
CHILD LOCK
The control panel can be locked so that the
microwave cannot be operated accidentally. Press
and hold the STOP/CLEAR button for 3 seconds to
set the child lock. The microwave will beep and the
lock icon will illuminate on the display to show that
the control panel is locked.
Press and hold the STOP/CLEAR button for 3
seconds to disable the child lock. The lock icon will
turn off and the microwave will resume normal
operation.
7