Danby DOM014401G1 Owner's Manual page 9

OPERATING INSTRUCTIONS - SENSOR COOK MENUS
Sensor cook menus are provided for cooking common foods. It is not necessary to program the time or
cooking power. Use the cooking chart to enter the type of food and after cooking for a period of time,
the microwave will detect the amount of steam inside the cooking cavity and will judge the corresponding
cooking time based on the amount of steam generated by the food. The countdown will display on the
screen.
If there is an error during cooking, the microwave will stop operation, the display will show "E-1" and
the microwave will beep every 2 seconds until the STOP/CLEAR button is pressed. If this error appears,
unplug the microwave, wait 3 - 5 minutes and then plug it back in. If the error persists, please contact our
consumer care department.
During cooking, press the STOP/CLEAR button or open the door or to stop the cooking program.
During long cooking programs, if the microwave is unable to detect steam produced by the food, the
cooking program will automatically end.
Use the chart below to indicate the type of food and the cooking program will be automatically set.
1. Press the SENSOR COOK button the desired number of times.
2. If cooking meat or vegetables, use the number pad to set the submmenu.
3. Press START/+30SEC to begin the program.
Press SENSOR COOK
Once
Twice
3 tmes
4 times
5 times
Code Menu Press #
A-1 Pizza
A-2 Potato
A-3 Meat 1
2
3
4
A-4 Veggies 1
2
A-5 Popcorn
Submenu
Pork
Chops
Ground meat
Chicken piece
Fresh
Frozen
8
Weight (oz) Weight (g)
5~16 140~450
6~24 170~680
5~24 140~680
7~21 200~600
3.2 90.7