Related Manuals for Juniper NFX250-S1
Summary of Contents for Juniper NFX250-S1
- Page 1 UNCLASSIFIED IDENTIFICATION OF VOLATILE AND NON-VOLATILE STORAGE SANITIZATION OF SYSTEM COMPONENTS JUNIPER NETWORKS NFX250-S1 REVISION 1.0 June 01, 2016 UNCLASSIFIED...
- Page 2 Power Down and Removal of Non-Volatile Storage ........2 System Power Down ................2 Disassembly of the NFX250-S1 Chassis and Identification of NV storage Removal of the SATA FLASH and SPI FLASH from the System Board .. 6 TABLE OF FIGURES Figure 2-1: NFX250-S1 ..................
- Page 3 Packet Forwarding Engine capacity, and a rich set of Layer 2 and Layer 3 features. The performance of the control plane running on all NFX250 devices is enhanced by the 2.0 GHz 6-core Intel CPU. NFX250-S1 has 16 GB of memory and 100 GB of enterprise grade solid-state drive (SSD) storage.
- Page 4 2/13/2020 Figure 2-1: NFX250-S1 2.2 Description of Field Replaceable Units (FRU) NFX250-S1 and NFX250-S2 doesn't have any Field replaceable units None of these components contain NV RAM. All NV RAM is either soldered or installed onto the system board. POWER DOWN AND REMOVAL OF NON-VOLATILE STORAGE...
- Page 5 3.2 Disassembly of the NFX250-S1 Chassis and Identification of NV storage The NFX250-S1 does contain NV storages that is replaceable.In order to access the memory for removal, refer to the following steps: 1. Remove the power supplies from the system.
- Page 6 UNCLASSIFIED 2/13/2020 Figure 3-2: Left side screws 5. Remove five screws from right side of chassis (figure 3-3) Figure 3-3: Right side screws 6. Remove the six screws from rear (figure 3-4) UNCLASSIFIED...
- Page 7 UNCLASSIFIED 2/13/2020 Figure 3-4: Rear screw 7. Remove the top of the chassis (figure 3-5) Figure 3-5: Open Chassis UNCLASSIFIED...
- Page 8 UNCLASSIFIED 2/13/2020 8. Locate NV storage (figure 3-6). Figure 3-6: Locate NV storage (SATA SSD) 3.3 Removal of the SATA FLASH and SPI FLASH from the System Board Once the NV storages has been located, follow the instructions below. a) Use screw driver to unscrew the screw and remove the SATA SSD module NOTE : Before removal, ensure J-TAC and the appropriate account team has been notified of your intentions.
Need help?
Do you have a question about the NFX250-S1 and is the answer not in the manual?
Questions and answers