Glide/Portamento And Velocity Modulation - Xils lab miniSyn'X User Manual

Reset LED (Located close to the DELAY Knob ) : Reset the LFO waveform to the beginning of
its cycle when a Note ON event is received
Midi Synchro LED (Located close to the FREQ Knob .): Click on this led to synchronize the LFO
rate to the tempo of the host. Please note that the rates will be displayed in musical notation if
the sync is engaged. (LED On)
Routing Select Buttons: Using these buttons the modulation setup on Depth A can be routed
simultaneously to the pitch and/or pulse width of the oscillator 1 and/or 2, and on Depth B to
the Filter frequency and/or the output level amplifier.
Note : please note that the miniSyn'X also offers another –Global- LFO which is tied to the
Joystick use. So you can have up to three independent LFOs per patch ( 1 Lower Layer, 1 Upper
Layer, 1 Global )
9.1.7

Glide/Portamento and Velocity Modulation

9.1.7.1 Glide and Portamento
FLT, O1, and O2 buttons : These buttons route the glide or the portamento, which has been
set up to the filter frequency or/and the oscillators pitch.
GLD : The glide select button enables the glide function for the selected glide/portamento
destination(s)
PORT: The Portamento select button enables the portamento function for the selected
glide/portamento destination(s)
SPEED: This knob sets the rate at which the glide or the portamento effect takes place.
AMOUNT: This knob sets the amount, +/- 32 semitones, of the glide effect. Each time a note is
triggered, the pitch of the selected destination begins from the actual note played +/- the
amount of the glide, then returns to the correct pitch during a time specified the speed knob.
9.1.7.2 Velocity
Velocity Modulation In this module, you can change the velocity modulation intensity over
the VCA and the VCF modules.
AMP : Change the amount of the velocity applied on the output level
FLT: Change the amount of the velocity applied on the filter cutoff frequency
- 24 -