Table of Contents
Advertisement
9.1.5
Noise Generator
WHITE/PINK: Allows you to select either white or pink noise to be added to the oscillators in
the mix going to the filter. White noise contains all the audible frequencies at equal level, while
pink noise contains all the audible frequencies at equal energy, meaning the more the
frequency increases, the more the level decreases.
VOLUME: This controls the level of the noise added to the oscillators.
9.1.6
LFO
The miniSyn'X proposes a per layer Low Frequency Oscillator, which can be used as a
modulation source.
FREQ : Controls the speed of the modulation effect.
DEPTH A, DEPTH B: Regulates the different amounts of the modulation, Depth A, for the
oscillator pitch Modulations and the pulse width modulation of Oscillator 1, Depth B for the
Filter and Output Amplifier modulation, and the Pulse Width Modulation of Oscillator 2.
Waveforms Buttons: The various switches select the different available LFO waveform(s).
Sine, Triangle, Saw, Ramp, Square, Random (S&H).
Please note that you can select different waveform simultaneously, and can therefore build
unusual and very complex LFO waveforms when combining several waveforms.
Tip: This is especially handy if you wish to add some subtle movements and modulations to an
instrument. Adding several waveforms to an LFO will avoid the repetitive feel of the LFO.
DELAY: Set the delay time between the note ON event and the beginning of the fade in.
FADE : Set the time for the Lfo output to rise from zero to the maximum level.
- 23 -
Advertisement
Table of Contents
