Table of Contents
Advertisement
Title "LP:" ON/OFF
To increase the space usable for a title, you can delete the recording mode name "LP:" that will be added immedi-
ately before the title.
In stop mode, press the SET button for two seconds or more. Each time you press the button, the display alternates
as follows:
TITLE LP: OFF Ô TITLE LP: ON
To delete from the title, select "TITLE LP: OFF". Otherwise, select "ON".
Note
The recorded "LP:" cannot be deleted (edited) with the TITLE function mentioned on page 14.
Adjusting the recording level (for analog input only)
The recording level should be adjusted so that the peak level meter does not reach the OVER mark to avoid distort-
ing the recording signal.
Press the 4 or ¢ buttons on the unit to decrease or increase the recording level.
You can change the recording level between "REC LEVEL 00" (nothing will be recorded) to "REC LEVEL 25".
Track marking (When recording LINE IN input signals)
• Whenever playback at the source side advances from one track to another during digital recording, the track
number of the MD is automatically incremented by 1.
• Whenever no sound at the playback side continues for 3 or more seconds during analog/digital recording, the track
number of the MD is automatically incremented by 1.
• During analog/digital recording, you can increment the track number by 1 by sliding the REC switch. (By adding the
track number in this way, you can edit the recording contents later using the edit functions, such as erase, move, and
join. Also, you can quickly locate the desired track using the fast forward or reverse button.)
Track marking (When recording MIC input signals)
You can choose the way to make a track for the MIC input, with the MIC IN MARK MODE switch on the bottom of
the unit.
• If you need to change the setting, you must set this switch before starting recording.
MANUAL: You can increase the track number by 1 by sliding the REC switch.
3 MIN:
The track number is automatically increased by 1 approx. every three minutes. You can also in-
crease it by sliding the REC switch.
10 MIN:
The track number is automatically increased by 1 approx. every 10 minutes. You can also increase
it by sliding the REC switch.
SYNCHRO Recording (SYNCHRO)
The synchro recording automatically starts when an input signal is given and ends if no signal condition continues
for 30 seconds.
• Use the buttons on the unit.
1
Insert an MD with its label side facing up.
Proceed to the next step after "TOC Reading" goes out on the display.
2
Slide the REC switch.
3
Press the SYNCHRO button.
The "SYNC" indicator lights up, and the current recording mode and "SYNCHRO" appear on the display.
Then, the disc mark blinks.
To cancel the synchro recording, press the SYNCHRO button again to go out the "SYNC" indicator.
Press the 6 button.
4
The "SYNC" indicator blinks, indicating that the unit enters Rec/Standby mode.
5
Play the recording source.
When an input signal is detected by the unit, recording automatically starts.
The recording will automatically end if no signal condition continues for 30 seconds.
Note
Once the 6 button is pressed during the SYNCHRO recording, the unit enters Rec/Pause mode and the SYNCHRO
recording is disabled. To restart the SYNCHRO recording, repeat the above steps.
10
Advertisement
Table of Contents
