Common Operations; Turning On The Power; Setting The Clock; Selecting The Sources And Starting Play - JVC UX-P55 Instruction Manual

Common Operations

Turning On the Power

When you press the play button—CD 3/8, TAPE 2 3, or
the source selecting button—FM/AM and MD/AUX, the unit
automatically turns on and starts playback if the source is
ready.
To turn on the unit, press
The STANDBY/ON lamp on the unit lights green.
STANDBY/ON
To turn off the unit (on standby), press
ON) again.
The STANDBY/ON lamp lights red.
• The CLOCK indicator flashes on the display until you set
the built-in clock. After setting the clock, the clock time
will appear on the display while the power is off.
• A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to "0:00" right away, while the tuner preset
stations (see page 11) will be erased in a few days.

Setting the Clock

Before operating the unit any further, first set the clock built
in this unit. When you plug the AC power cord into the wall
outlet, the CLOCK indicator starts flashing on the display.
You can set the clock whether the unit is on or off.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
On the unit ONLY:
1
Press CLOCK for more than 2
seconds.
The hour digits start flashing on the display.
CLOCK
(STANDBY/ON).
STANDBY/ON
STANDBY / ON
(STANDBY/
CLOCK
2
Press ¢ or 4 to adjust
the hour, then press CLOCK.
The minute digits start flashing on the
display.
CLOCK
3
Press ¢ or 4 to adjust
the minute, then press
CLOCK.
The CLOCK indicator remains lit on the
display.
CLOCK
To check the clock time
Press DISPLAY on the remote control (or
CLOCK on the unit) while playing any source.
• Each time you press the button, the source
indication and the clock time alternate on the
display.
• When you unplug the AC power cord or if a power failure occurs,
the clock loses the setting and is reset to "0:00." You need to set
the clock again.
• The clock may gain or lose 1 to 2 minutes per month.

Selecting the Sources and Starting Play

To play back CDs, press CD 3/8. (See pages 14 – 16.)
To play back tapes, press TAPE 2 3. (See page 17.)
To listen to the FM/AM (MW/LW) broadcasts,
press FM/AM. (See pages 11 – 13.)
To select the external equipment as the source,
press MD/AUX.
TAPE
CD
– 9 –
CLOCK
CLOCK
DISPLAY
CLOCK
FM/AM MD/AUX