Operation - Silvercrest SAST 18 A1 Operating Instructions Manual

■ Recharge the batteries again if the appliance's suction power becomes
appreciably weaker and the charge indicator lamp
NOTE
► If the charge indicator lamp
batteries are fully discharged and the appliance will switch off after around
1 minute.
► The appliance can also be charged directly via the mains adapter
do this, remove the barrel plug
and insert it into the socket on the appliance.
► The appliance cannot be operated during charging.

Operation

ATTENTION!
► The suction opening must always be open and may not be blocked.
Blockages lead to overheating and damage to the motor.
► Use the wet-suction nozzle
NOTES
► Make certain that the HEPA filter
► When vacuuming liquid, do not exceed the MAX marking in the dirt
container
► If the motorised brush attachment
longer rotate, the appliance will switch off. The charge indicator lamp
flashes red and the working light
blockage as in the section "Cleaning the brush attachment". To reactivate
the appliance, push the On/Off switch
back into the mode that you want to use ("I" or "II").
1) Remove the appliance from the wall bracket
wall bracket
2) If required, place the appropriate nozzle in the suction opening. See section
"Using accessories".
3) To switch the appliance on, slide the On/Off switch
position I (= low power/wet suction
The charge indicator lamp
The working light
4) To switch the appliance off, place the On/Off switch
position. All lamps go out.
■ 28 │ GB │ IE
flashes alternately green and red, the
from the wall holder
only at level I (low/wet suction
.
, remove the barrel plug
lights up yellow at level I, green at level II.
lights up.
flashes green.
is inserted before using the appliance.
is blocked so that the brush can no
goes out. If this happens, remove the
to the "OFF" position and then
or, if you are not using the
from the socket.
forwards into
) or position II (= high power).
back to the "OFF"
. To
with a slight twist
).
SAST 18 A1